超疏水表面(superhydrophobic surface)因其自我清潔效果在近年來引起廣泛的研究及探討，目前世界各大公司皆積極投入自潔性產品(超疏水表面)的研發，但是截至目前為止除了塗料及織物有產品外，其他尚在研發階段。降低表面能及增加表面粗糙度為製作超疏水性表面的兩種方法。本實驗我們針對使用不同方法去仿照自然界植物「蓮花效應」，將二氧化矽粒子適當的分佈在基材表面，以增加粗糙度，製造出超疏水性表面。我們發現鍛燒會使其二氧化矽粒子黏聚在一起，對接觸角的增加無幫助。而在溶膠凝膠的配置過程中直接加入OTS(Octadecyltrichlorosilane)，並利用光散射儀比較二氧化矽奈米顆粒的平均粒徑及粒徑分佈隨時間變化的情形，一段時間後發現會有明顯大顆粒沉澱，塗佈在玻璃基材表面後容易脫落，不適合往後實驗或其他用途。而以氨水催化的溶膠凝膠以不同流速滴入TEOS (Tetraethylorthosilicate，四乙氧基矽)對接觸角的影響也不大。最後我們利用砂紙在基材表面上刷磨，可以使二氧化矽粒子分佈均勻，明顯增加接觸角。塗佈速率的改變搭配疏水性矽烷單分子膜的改質，我們已可以製造出159°的超疏水性表面。Superhydrophobic surfaces are generally made by lowering the surface energy and increasing the surface roughness. In this experiment, we use different methods of spreading silicon dioxide nanoparticles properly on the surface in order to increase the surface roughness and also make superhydrophobic surfaces. In the beginning, we find that the calcinations can cause its silicon dioxide nanoparticles to stick together instead of increasing the contact angles. Then, add OTS (Octadecyltrichlorosilane) directly to manufacture process of sol-gel, and observe the situations of the average length and the spread of silicon dioxide nanoparticles with the time goes by. After a period of time, we will discover that many obvious big particles deposit and spin-coating on the glass surfaces flop easily. Hence, this phenomenon is n’t proper for the following experiments or other uses. However, the contact angles have nothing to do with dropping the sol-gel catalyzed ammonia to TEOS(Tetraethylorthosilicate) by different flowing rates. Finally, it is crucial for us to use the sandpapers to brush on the surfaces because it may cause the silicon dioxide nanoparticles to spread well and obviously increase the contact angles. Combining the silicon dioxide surfaces with the change of spin-coating rate and the cover with hydrophobic SAM, we have made the superhydrophobic surfaces of 159°.
「為配合國家發展委員會「推動ODF-CNS15251為政府為文件標準格式實施計畫」，以及 提供使用者有文書軟體選擇的權利，本館檔案下載部分文件將公布ODF開放文件格式， 免費開源軟體可至LibreOffice 下載安裝使用，或依貴慣用的軟體開啟文件。」